Wednesday, November 18, 2026

3D Printed Personalised iPad Stand

 

Challenge: To design a personalised iPad stand.

Background: We mentioned in the previous post about a ChatGPT generated prompt poster that had a range of challenges for the students in our classroom.  While this was targeted at students with experience we did ask for more challenging prints - which was a mixture.   One of the tasks identified resulted in the students creating a range of table labelled wedges.

The student in this case opted for the iPad stand.   We have had a number of these be showcased throughout the years, created by students and the library of them can be located on the top right hand corner search bar.

In this instance the student was able to create a range of them easily using basic Tinkercad design ideas.

The student used their design skills to introduce a significant name stencil into the front of the design which can be clearly seen from the illustration.

Level of Difficulty: Low - this is not a particularly challenging design and aspects of it are rather straightforward - the personalisation is achieved by the name being prominently featured.

Resources to complete this project: Tinkercad App, iPad, Bambu H2D, Bambu Orange PLA.

Size As this is intended to support an iPad (and an iPad in a protective case) the dimensions of this are required to be significant.   The Print measures 150mm across at the front is 70mm deep.  The print stand at the front is 60mm high (which is the part of the stand that contains the lettering) and the back of the stand is 100mm tall.

Cost: To produce this print the printer used 125g of regular PLA to complete the print.  This had a price point of $2.00.

Timeframe:  On the Bambu H2D the printer was operating for a total of three hours and five minutes to complete the print, this was with the regular default infill settings (of fifteen percent).

What we would do differently/Next steps for the students: The lettering at the front of the design is effective however it appears to be a little fragile as the student opted to have the stencil like finish and have the design pass through the entire design - it could have been opted to be created with a backing plate.   An orange finish was created by using the PLA but the student could also opt to spray paint this design for a different affect.  The large space on the back of the design is where alternative designs or potentially a large sticker from the Roland Versa Sign Maker could be placed.

No comments:

Post a Comment