Virtual Designs: Christmas Theme - Part Two

 

We've started moving towards the end of the school year in New Zealand as we have a school year that runs from February to December - at Auroa Primary School our students have a week remaining.

There's a range of projects that we are trying to complete before the year comes to a close.   Some have a festive theme.   We have used our iPads, the Tinkercad App to create designs, but for the purpose of publishing we have looked to combine a range of 3D Printing with some virtual printing.  In this example shown left the 'bauble theme' from Pic Collage has been crossed with a Tinkercad design that was modified by the student.   It was exported from Tinkercad via the AR/VR feature and then imported into Pic Collage where the AR/VR filters that are currently available were applied

We are then taking the image and going to then publish it as the front page of a Christmas Card, with the student using other apps to produce the lettering and the message to go inside the card.    The design was modified by an eight year old and worked on independently so the teacher didn't have any input into the process.  There are other examples located here or as always you can use the search bar top right to search this entire blog.

A montage of student photos from our recent Virtual Christmas Tree challenge.   Again as detailed previously we used Tinkercad to create from scratch a virtual Christmas tree complete with decorations.  Students then used the Tinkercad App to project the tree around our school grounds in a variety of locations and sizes.  The students had to rotate the tree in each shot to show a different view of it and include in the decorations some unusual shapes or objects as 'easter eggs'.   The process took a block (an hour of teaching) from start to finish - the student was an eight year old who design the tree independently and then went around the school themselves to complete the VR/AR imaging.  This is not intended to be a fully print using the printers.