Saturday, August 22, 2020

3D Printed (and Laser Cut) Stamp


Challenge: For student who had worked on previous projects to produce a working stamp for a design business (for an adult).   The print was divided into two parts - the stamp itself was produced by using a laser cutter (which is onsite at our school) to cut specifically the stamp design.   The base and the handle of the stamp were then custom made and produced using a 3D Printer.

Background: This student had considerable experience with 3D Printing in the past, and had produced a number of projects in the past, which have been used as prints and examples on this site.   With this print the student was very pro-active in using the printer.   They had the entire design in mind, and having previously seen the examples produced using just a 3D Printer (featured here on this blog) the student was keen to use rubber specific to the task.  We had previously ordered some of this from a commerical supplier located in New Zealand.    Once the component parts were put together the design followed.   The entire project was completed in a morning at school, the time involved with the design was minimal and the results, when used with an ink pad, were extremely positive.    A very successful project.

Degree of Difficulty: The key aspect of this was the collection of the required gear specific to the print.   The stamp specific print has produced a nearly professional quality print which is much more even than the paint and print versions that have been created directly by 3D Printer (see posts about this on this blog).   The actual print for the base of the stamp and the handle was extremely straightforward, just a basic rectangle increased in size to mount the stamp and a handle to.

Size: The base of the stamp is a rectangale 13cm across, 2cm thick and six centimetres long.   The handle part of the stamp extended a further 5cm from its base.   

Timeframe: Three and a half hours to print the base, the laser cutting of the stamp from the rubber took less than fifteen minutes.   Given the goal of the post/project this was an excellent result.

What we would do differently: This was a student driven project that was created with a specific goal in mind, was student driven and completed and the teacher had minimal input into the process.

The completed design, used with stamp ink was able to produce the stamp shown on the left when combining the 3D Print with rubber.

No comments:

Post a Comment